CCTV Tester Pro Instrukcja Użytkownika Pobierz pdf (Strona 18)

FUNCTIONAL USE

Power ON/OFF

The power switch is located on the side of the

handset.

Turn the power switch on, and press

to start

SecuriTEST.

To turn off the system, press & hold

for more

than 3 sec. Then, POWER OFF is displayed on the

main screen with a beep. Release the button. Turn

the power switch OFF to prevent battery drain during

storage. The switch must remain ON to recharge the

batteries.

A rechargeable battery should be plugged in over 8

hrs to fully charge. The charged battery can operate

for about 3 hours.

When the battery indicator shows below [][], recharge

it for use. (Full charge: [][][][])

OSD Setup Screen When Power is ON

When power is turned on, the OSD is displayed, and it

automatically changes to the video test mode after 3-5

seconds.

The initial OSD displays the SecuriTEST version and the

initial setup on the screen.

Product Version: 2.02

Firmware Version: 2.03

Initital Protocol: PELCO-D

TV Mode: NTSC / PAL (automatic setup)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Brak uwag

CCTV Tester Pro Instrukcja Użytkownika Strona 18